Homelite UT43123 Manual Del Operador página 31

NOTE: Do not replace the screw with an ordinary
screw. Use only identical replacement parts from
the manufacturer when replacing parts.
In addition to preventing chain contact with solid
objects at the nose of the bar, the SAFE-T-TIP also
helps keep the chain away from abrasive surfaces,
such as the ground. Keep it on the right hand side
of the bar where it will be between the chain and
the ground during flush with ground cutting.
The mounting screw requires a 5/16 in. wrench (or
adjustable wrench) to achieve the recommended
torque of 35 to 45 in.lb. A torque within this range
can be achieved by using the following method.
 Tighten the screw with wrench until snug.
 From the snug position, tighten the screw an
additional 3/4 of a turn using a wrench.
MAINTENANCE
TRANSPORTING AND STORING
 Do not store or transport the chain saw when
 Disconnect chain saw from power supply.
 Always place the sleeve on the bar and chain
 Clean the chain saw thoroughly before storing.
 Keep away from corrosive agents such as gar-
CALL US FIRST
For any questions about operating or maintaining your product,
call the Homelite Help Line!
Your product has been fully tested prior to shipment to ensure
your complete satisfaction.
Page 31 — English
it is running. The chain saw should always be
idle before storing or transporting.
before storing or transporting the chain saw.
Use caution to avoid the sharp teeth of the
chain.
Store the chain saw indoors, in a dry place that
is locked and/or inaccessible to children.
den chemicals and de-icing salts.