Evaluating Results - Beurer BM 45 Manual De Instrucciones

Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• To start the blood pressure monitor, press
the Start/stop button
illuminate briefly.
The blood pressure monitor will begin the
measurement automatically after 3 seconds.
The cuff automatically inflates.
Measuring can be cancelled at any time by pressing
the Start/stop button
The cuff's air pressure is slowly released. If you already
recognise a tendency for high blood pressure, you should
reinflate the cuff and increase the cuff's pressure again. As
soon as a pulse is found, the pulse symbol
• Systolic pressure, diastolic pressure and
pulse measurements are displayed.
. All displays will
.
is displayed.
• appears if the measurement could
not be performed properly. Observe the
chapter on error messages/troubleshooting
in these instructions for use and repeat the
measurement.
• Now select the desired user memory by pressing the
M1 or M2 memory buttons. If you do not select a
user memory, the measurement is stored in the most
recently used user memory. The relevant symbol M1 or
M2 appears on the display.
• Using the Start/stop button
pressure monitor. The measurement is then stored in
the selected user memory.
If you forget to turn off the device, it will switch off
automatically after approx. 3 minutes. In this case too,
the value is stored in the selected or most recently used
user memory.
• Wait for at least 1 minute before taking
another measurement.

6. Evaluating results

Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia disor-
ders during measurement and if necessary indicates the meas-
urement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a condi-
tion where the heart rhythm is abnormal as a result of defects
25
, switch off the blood
.