Descargar Imprimir esta página

Moser 4463 Instrucciones De Uso página 11

Plancha alisadora

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
All manuals and user guides at all-guides.com
· Keep the mains cable away from hot surfaces.
· Do not wind the mains cable around the hairdryer.
· Make sure that the mains cable is not twisted or kinked when stored.
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
released.
· To prevent injury, never use the appliance if the heating elements are damaged.
· As additional safety measure, it is recommended that a tested residual current appliance
(RCD) with a residual operating current of not more than 30 mA be installed in the bathroom
circuit. Your electrician will be pleased to help you.
· Dispose of unusable appliance in accordance with the legal provisions of the country in
which the appliance was purchased.
· We are not liable for damage caused as a result of improper use or failure to observe these
operating instructions.
· The appliance is safety insulated and radio screened. It meets the requirements of EU
Directive 2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive
2006/95/EC.
Coating with CERAMIC, TOURMALINE and NANO SILVER technology
The coated heating plates have an antistatic effect and are gentle to the hair. Negative ions
close the scale layer, creating a smooth, silky hair surface. and lock in the natural moisture of
the hair, thereby creating the ultimate shine. Negative ions also remove the static charging of
the hair surface. The innovative nano silver technology sterilises bacteria.
Operation
· Connect to the mains power supply.
· Using the on/off switch (B), switch on the appliance (Fig. 1). Press and hold the on/off switch
until the temperature display (D) flashes red.
· Set desired operating temperature with the temperature toggle switch (C). To increase the
temperature, move the toggle switch slightly, in the UP direction (Fig. 2a). To reduce the
temperature, move the toggle switch (C) slightly, in the DOWN direction (Fig. 2b). The tem-
perature can be set between 130°C – 230°C in 20°C increments.
· The appliance reaches the set operating temperature within a very short time. The red tem-
perature display LED comes on.
· After use, switch off the appliance with the on/off (B) switch (Fig. 1). Press and hold the on/
off switch until the temperature display goes out.
· For safety reasons, the appliance switches itself off automatically after 30 minutes. For con-
tinued use, the appliance will need to be switched on again (Fig. 1).
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
Tips for successful styling
· Wash hair, rinse and dry well.
· Brush or comb hair.
· Section off individual strands of hair.
· At the hairline, place a section of hair between the heating plates.
· Keep the straightener pressed together for a few seconds and slowly pull it down the section
of hair away from the head.
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
9

Publicidad

loading