Kenwood CH580 Serie Instrucciones página 4

the lower blade. This is normal as
the blade assembly is designed to
be loose fitting to ease separation
after use.
1 Put the bowl base on the bottom
of the bowl. (This stops the bowl
sliding on the work top).
2 Place the unit on a clean, flat
surface.
3 Fit the desired knife blade
assembly into the bowl over the
locating pin
4 Cut the food into suitably sized
pieces and place in the bowl.
Larger pieces of food should be
cut into approximately 1 to 2 cm
pieces.
5 Fit the cover and turn clockwise to
lock into place
6 Place the power unit onto the
cover.
7 Connect to the power supply and
press down on the speed selector
to select the desired speed. When
operating the power unit, hold it
firmly on the cover and bowl.
Press the speed selector lightly to
G
obtain speed 1.
Press the speed selector firmly to
G
obtain speed 2.
Alternatively the speed selector
G
may be pressed down for short
periods of time to produce a
pulsing action. This can be used to
avoid over processing food.
8 Operate the food chopper until the
desired result is achieved.
9 Switch off and unplug after use.
10 Reverse the above procedure to
dismantle the unit.
important
If preparing food for babies or
G
young children, always check that
the ingredients are thoroughly
blended before feeding.
Do not run the food chopper
G
continuously for longer than 10
seconds. Leave to cool for 1
minute in between each 10 second
operation.
Do not operate the food chopper if
G
the bowl is empty.
Never operate the food chopper
G
with the bowl filled with liquid.
.
.
Always allow hot food to cool
G
before processing.
hints
If the chopper labours, remove
G
some of the mixture and continue
processing in several batches,
otherwise you may strain the
motor.
Remember that chopping hard
G
foods such as coffee beans,
spices, chocolate or ice will wear
the knife blades faster.
Beware of over processing some
G
ingredients. Stop and check the
consistency frequently.
Various spices such as cloves, dill
G
and cumin seeds can have an
adverse effect on the plastic of
your food chopper.
To ensure even processing, stop
G
and scrape down any food from
the side of the bowl with a plastic
spatula.
The best results are obtained by
G
chopping small quantities at one
time.
Cut larger pieces of food into 1-
G
2cm pieces. A large load or large
pieces may cause uneven results.
Before chopping nuts, herbs,
G
breadcrumbs etc, ensure that both
the food and the blade, bowl and
cover are thoroughly dry.
to use the mayonnaise
dripper (if supplied)
Please refer to the mayonnaise
recipe in the recipe section for
information on how to assemble
and use the mayonnaise dripper.
care and cleaning
Always switch off and unplug
G
before cleaning.
Handle the blades with care
G
- they are extremely sharp.
Some foods may discolour the
G
plastic. This is perfectly normal and
won't harm the plastic or affect the
flavour of your food. Rub with a
cloth dipped in vegetable oil to
remove the discolouration.
4