Publicidad
Idiomas disponibles
Idiomas disponibles
Other recommended accessories for use with
GB
this laser are available at extra cost from your
local dealer or authorized service centre. If
you need assistance locating any accessory,
please contact your nearest STANLEY service
centre or visit our website: www.2helpU.com.
Maintenance
• When the laser is not in use, clean the
exterior parts with a damp cloth, wipe the
laser with a soft dry cloth to make sure it is
dry, and then store the laser in the kit box
provided.
• Although the laser exterior is solvent
resistant, NEVER use solvents to clean
the laser.
• Do not store the laser at temperatures below
-5 ˚F (-20 ˚C) or above 140 ˚F (60 ˚C).
• To maintain the accuracy of your work,
check the laser often to make sure it is
properly calibrated.
• Calibration checks and other maintenance
repairs may be performed by STANLEY
service centres.
Troubleshooting
The Laser Does Not Turn On
• Check the AA batteries to make sure:
• Each battery is installed correctly,
according to (+) and (–) listed inside the
battery compartment.
• The battery contacts are clean and free
of rust or corrosion.
• The batteries are new, high-quality, name
brand batteries to reduce the chance of
battery leakage.
14
• Make sure the AA batteries are in proper
working condition. If in doubt, try installing
new batteries.
• When using rechargeable batteries, make
sure the batteries are fully charged.
• Be sure to keep the laser dry.
• If the laser has been stored in extremely hot
temperatures, allow it to cool. The laser level
will not be damaged by using the Power/
Transport Lock switch before cooling to its
proper operating temperature.
The Laser Beams Flash
When in self-levelling mode, the lasers are
designed to self-level up to an average of 4° in
all directions. If the laser is tilted so much that
the internal mechanism cannot level itself (or
the laser is not level when in manual mode),
the laser beams will flash indicating that the tilt
range has been exceeded.
THE FLASHING BEAMS CREATED BY
THE LASER ARE NOT LEVEL OR PLUMB
AND SHOULD NOT BE USED FOR
DETERMINING OR MARKING LEVEL OR
PLUMB. Try repositioning the laser on a more
level surface.
Laser Beams Will Not Stop Moving
The laser is a precision instrument. Therefore,
if it is not positioned on a stable (and
motionless) surface, the laser will continue
to try to find level. If the beam will not stop
moving, try placing the laser on a more stable
surface. Also, try to make sure that the surface
is relatively flat and level, so that the laser is
stable.
Publicidad
