Publicidad
Step 11
Insert four SMALL HIDDEN CAMS (3) into the
å
LOWER ENDS (B and D).
Fasten the LOWER ENDS (B and D) to the SHELF (H).
å
Tighten four HIDDEN CAMS.
Fasten the LOWER ENDS (B and D) to the SHELF
å
MOLDING (J). Use two SILVER 1-1/2" FLAT
HEAD SCREWS (18).
Fasten the SHELF MOLDING (J) to the LOWER
å
ENDS (B and D). Use two SILVER 1/2" PAN HEAD
SCREWS (21) through the METAL BRACKETS and
into the LOWER ENDS.
B
J
414816
SILVER 1/2" PAN HEAD SCREW
(2 used in this step)
H
J
B
18
SILVER 1-1/2" FLAT HEAD SCREW
(2 used in this step)
www.sauder.com
1
2
3
The arrow must
point toward the
edge of the board.
21
J
D
3
D
The holes are
closer to this edge.
Page 15
Publicidad
