Publicidad
Step 15
Hold the BRACE (K) between the LOWER ENDS (B and D)
å
clear of all plumbing obstacles to determine which set of holes
to turn your ANGLED HEAD CAM SCREWS (2) into.
Remove the BRACE and turn two ANGLED HEAD CAM
å
SCREWS (2) into each of the set of six holes in the
LOWER ENDS (B and D).
Insert four LARGE HIDDEN CAMS (1) into the BRACE (K).
å
You may need to slightly widen the LOWER ENDS (B and D) to
å
fasten the BRACE (K) to them. Tighten four
HIDDEN CAMS.
D
414816
B
Angled head
2
www.sauder.com
1
2
3
The arrow must
point toward the
edge of the board.
1
K
Page 19
Publicidad
