Epson ELPLX01 Manual Del Usuario página 4

v When projecting, remove the lens cover from the front of the lens unit.
v Before attaching the lens unit, check the projector's model number. If this lens unit is attached
to a projector other than the specified projector, the lens unit or the projector could be
damaged.
v When the projector is installed on the ceiling, uninstall the projector, and then attach or
remove the lens unit in a safe location.
v Be careful not to trap your finger when attaching this product to the projector. This may cause
an injury.
v Do not disassemble or remodel.
v Do not use or store the projector in places where it might be subjected to high and low
extremes of temperature.
v Do not use or store the projector in places where smoke from oil or cigarettes may be present,
as it can adversely affect the quality of the projected images.
v Do not get it wet.
v Do not drop it or subject it to impacts. When putting this product down, make sure you place
it on a flat, stable surface.
v When moving the projector, do not hold the lens unit. The lens unit may come off and the
projector may fall causing an injury.
v Remove the lens unit when transporting the projector. If the projector is transported with the
lens unit attached, the lens unit or the projector could be damaged.
v Turn off the projector and then wait for a while (approximately 30 minutes) before removing
the lens unit. If you touch the lens unit during projection or immediately after turning off the
projector, it could cause a burn.
v If the lens shift has been done, move the lens position to the home position before replacing
the lens unit.
v Do not touch or pull the connector part or the cable as this could cause a malfunction.
v When cleaning this product, do not use a wet cloth or solvents such as alcohol, benzene, or
thinner as this could cause an electric shock or a malfunction.
4
Caution