Publicidad
Step 17
This is a two person step. Tip your unit onto its front edges.
å
Pull up on the levers of the RACK TENSIONERS (121M) until you hear
å
a click. This disengages the wheel from the LEFT and RIGHT RACK
DRIVE SETS (122M) to prepare for insertion of the LIFT TOP.
For support on the front of the unit, you will need to place packing foam
å
or magazines underneath the edge of the ENDS (A and B) as shown.
To insert the LIFT TOP assembly into your unit, line up the
å
EXTENSION SLIDES on the LIFT TOP ENDS (G and H) with the
EXTENSION RAILS on the ENDS (A and B) and push the LIFT TOP
assembly into the unit until it is fully inserted. It should then slide in
and out easier.
121M
G
Page 22
B
Lever
122M
121M
122M
H
422407
Pro Tip: Lift with your
legs. And, you know,
your arms.
Lever
A
For support, place packing
foam and magazines here.
www.sauder.com/services
Publicidad
