Publicidad
Step 19
The cable at the top of the CYLINDER will come assembled for optimal
å
performance. With an adjustable wrench, you can adjust the two nuts on both sides
of the cylinder bracket. The same length of threads should be on both sides of
the nuts as shown in the large diagram. Be sure to tighten the nuts after making
adjustments.
Push the end of the cable through the large hole in the LIFT TOP BACK (F) as shown in the
å
large diagram.
The two nuts on both
sides of the cylinder
bracket can be
adjusted. For optimal
performance, the
same length of threads
should be on both
sides of each nut.
F
Page 24
Push the cable through this hole.
The MODESTY PANEL and LIFT TOP
have been cut for clarity of assembly
422407
www.sauder.com/services
Publicidad
