Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Mounting
Plate
Step 1. Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 14)
Mounting ring
Mounting
plate
Figure 14
Screws
CAUTION:
Before
starting
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
1. Remove 1 of 3 screws from the mounting plate
and loosen the other 2 screws. (Do not remove)
2. While holding the LED light kit under the fan
motor assembly, make the 2-pin wire connections:
- White to white
- Blue to blue
3. Place the key holes in the LED light kit over
the two mounting screws previously loosened
from the mounting plate. Turn the LED light kit
until the LED light kit locks in place at the
narrow section of the key holes. Secure by
tightening the two screws previously loosened
and the one previously removed. (Fig. 15)
4. Raise the diffuser up against the LED light kit
and secure it to the fan by turning the diffuser
clockwise until snug. DO NOT OVERTIGHTEN.
(Fig. 15)
Installing the Light Kit
installation,
Wire connector
LED
Light kit
Figure 15
Mounting
plate
Screws
Diffuser
8.
Publicidad
