Installing The Reversible Shredding Disc - KitchenAid KFP1356 Instrucciones

ASSEMBLING THE FOOD PROCESSOR
Place the dicing kit lid on the work bowl
5
with the feed tube just to the left of the
dicing grid center. Grasp the feed tube
and turn the cover to the right until
it locks into place.
Installing the r_ever_sible shr_edding disc
Drop the drive adapter over the
1
power shaft.
TIP: You may need to adjust the drive
adapter with a slight turn on the power
shaft until it drops into place.
Drop the assembled disc onto the drive
3
adapter and push until it clicks firmly
into place.
W10782139A_EN_v04.indd 13
After dicing, remove the work bowl
6
cover and dicing blade, then insert the
dicing kit clean out tool into the dicing
kit base, and fold down to push any
extra food through the grid.
Hold the reversible shredding disc by
2
the finger holes with the desired side
(medium or fine) facing up; then push
the disc adapter into the bottom of
the disc.
Install the work bowl cover, being sure
4
it locks into place.
13
2/26/15 2:32 PM