Zeegma Zonder Robo Next Manual De Usuario página 11

PROBLEM POTENTIAL CAUSE
The vacuum cleaner No connection with the
does not charge. docking station.
The battery does not charge.
The vacuum cleaner The vacuum cleaner wraps in
has difficulties in elements of the room (cables,
vacuuming. drapes, etc.).
The vacuum cleaner Low battery.
returns to the
docking station
End of work time.
automatically.
The vacuum cleaner Vacuum cleaner is off
does not activate
Low battery
during scheduled
vacuuming.
Dustbin is clogged or other
elements are obstructed.
Remote control does Batteries in remote control
not work are flat.
The vacuum cleaner is off or
battery is low.
Infrared signal is not received
by the device.
APPLICATION
1. Download and install „WeBack" application (see fig. 16)
•
Scan QR code or find „WeBack" application in GooglePlay store or iOS store, download
it and install.
2. Sign up/ log in (see fig. 17)
•
Enter the application, enter your phone number or e-mail address. Enter your
password to receive the verification code. Next read and accept the Privacy Policy.
•
Enter the verification code in the empty field. Go further.
•
Next log in the application by entering the correct phone number or e-mail address
and password.
3. Scan the vacuum cleaner with QR code (see fig. 18)
•
Log in the application, click „+", scan QR code on mobile device and click „enter
manually".
SOLUTION
Make sure charging ports of the vacuum cleaner and
docking station are properly connected. Try to place the
product on the docking station manually.
Make sure the docking station is plugged in. If you have not
used the vacuum cleaner for a long time and battery does
not charge, place the cleaner on the docking station and
charge for 3 minutes, then stop charging. Repeat 3 times
and then start charging the vacuum cleaner normally.
The vacuum cleaner tries to steer clear of obstacles. If it
is impossible, remove obstacles before you start another
vacuuming.
This operation is normal.
This operation is normal.
Switch the vacuum cleaner on.
Charge the battery.
Switch the device off and clean the dustbin and filters.
Replace batteries in the remote control.
Switch the device on and/or charge the battery.
Clean the infrared sensor on the device and remote
control. Check the space between the remote control
and device for any obstacles blocking the signal and other
items emitting infrared signal (e.g. TV remote control).
EN