Turning The Hdmi Audio On/Off; Turning The Night Mode On/Off - Yamaha DVD-S661 Manual De Instrucciones

Setup Menu
48KHz
Select this to play back discs recorded at the
sampling rate of 48 kHz. All 96 kHz PCM data
streams (if available) are converted to the
sampling rate of 48 kHz.
96KHz
Select this to play back discs recorded at the
sampling rate of 96 kHz. If the 96 kHz disc is
copy protected, the digital output is
automatically converted to the sampling rate of
48 kHz.
4
Press 5/a to select a setting, and then
press ENTER.

Turning the HDMI audio on/off

When you connect this unit to an HDMI
compatible component via the HDMI jack,
select to turn on or off the HDMI audio output.
1
In "AUDIO SETUP PAGE", press 5/a to
highlight [HDMI AUDIO], and then
press 3.
ON
Select this to turn on the HDMI audio output.
OFF
Select this to turn off the HDMI audio output.
Notes
• If you are not using the HDMI audio output, set
this to [OFF].
• If the monitor/receiver connected to this unit
using HDMI does not support HDMI audio signal
input, set this to [OFF].
• This unit can output the following audio signals
using HDMI: 32/44.1/48 kHz, 2ch linear PCM
signals and bitstream signals (Dolby Digital, DTS
and MPEG).
• When audio signals are being output by HDMI-
compatible components, digital output signals are
muted.
26
En
• When [DIGITAL OUTPUT] is set to [OFF] on
this unit, HDMI audio is muted even if [HDMI
AUDIO] is set to [ON] and an HDMI connection
is established between the monitor and receiver.
• When [DIGITAL OUTPUT] is set to [ALL] on
this unit, PCM signals are still output if the
monitor and receiver only support the PCM
format. However, the audio output is muted when
audio format plays back the DTS source.

Turning the night mode on/off

In the night mode, high volume output is
softened and low volume output is brought
upward to an audible level. It is useful when
you want to watch your favorite action movie
without disturbing others at night.
1 In "AUDIO SETUP PAGE", press 5/a
to highlight [NIGHT MODE], and then
press 3.
ON
Select this to level out the volume. This
feature is only available for movies with the
Dolby Digital mode.
OFF
Select this when you want to enjoy the full
dynamic range of surround sound.
2 Press 5/a to select a setting, and then
press ENTER.