Sani-tip 122280N Manual Del Usuario página 3

ADAPTER INSTALLATION INSTRUCTIONS
1
1. Remove existing thumb
nut and syringe tip. Insert
enclosed hex key into
center hole of press ring.
Turn counterclockwise to
disengage and remove as-
2
sembly.
2. IMPORTANT!
Remove guide pin located
below threaded syringe
opening
3
3. After removing guide pin,
Replace existing O-Ring
remove existing o-ring seated
inside central water outlet
and replace with new o-ring
provided
4
4. Verify new adapter
o-ring
USER INSTRUCTIONS
q
.
p
.
n
has
o
in position as shown.
1
1. With thumb nut loosened, insert new Sani-Tip disposable tip and
push into adapter as far as possible. While still pushing inward, twist
tip 1/2 turn clockwise to create a watertight seal over internal tapered
water spindle.
2 2. Hand tighten thumb nut. To redirect tip, push in on tip while rotating
clockwise.
TEST PRIOR TO EACH USE: Express water, then express air only.
If air contains moisture, or tip dislodges, refer to Troubleshooting sec-
tion.
3. To replace tip, loosen thumb nut. Remove and discard used tip.
Repeat steps 1 and 2.
5
5. Place new adapter
onto long end of hex
key. Guide adapter
into syringe opening
as shown. Carefully
align threading and
tighten.
6
6. Verify o-ring
in place inside large
O-Ring
opening of white
plastic cone
7. With o-ring in place,
7
firmly snap large end
of white plastic cone
over adapter rim.
8. Hand-thread thumb
8
nut onto adapter. Do
not tighten until new
tip has been inserted.
Installation is complete.
m
is
l
.
3