Declaration Ce Of Conformity - Sea-Land Verti 123 M Instrucciones De Instalación, Seguridad Y Uso

10.2 Troubleshooting
FAULTS
The pump does not 1) No mains voltage.
work.
2) Impeller blocked.
3) The float switch does not work (only
automatic versions).
The pump works, 1) Water level under min. suction level.
but it does not 2) Air bubble in the pump created during
deliver water. immersion. This might happen when the
float switch is not well regulated and
does not stop the pump at the min. level
so that it sucks air.
3) Suction hole blocked.
4) Delivery hose blocked.
The thermal 1) The voltage does not correspond
overload protector to the indication shown on the motor
switches off the plate.
pump due to 2) A solid object has blocked the
overheating. impeller.
3) The pump has run dry for more than
15 minutes.
The "Aut" version of 1) The float switch does not operate.
the pump does not
stop.
CHAP. 11 MECHANICAL RISKS
11.1 Mechanical parts subject to wear
a) The mechanical seal (dr. 17) must be replaced even if
it has only been removed for inspection;
b) Bearings (dr. 8);
c) Impellers (dr.16).
ATTENTION: The above spare parts may only be
replaced by qualified technicians or at service centres
and only original spare parts may be used.
11.2 Risks due to extreme temperatures
a) The liquid inside the electric pump may freeze at low
temperatures (under 0 °C). This is very dangerous for all
the parts of the electric pump and may cause serious
damage to it;
b) A temperature higher than 40 °C may be dangerous
for the motor.
REASONS REMEDIES
1) Check if the socket is under voltage and
if the plug is well inserted.
2 ) Check that suspended bodies do not
block the impeller.
3) Check the float switch lifting it by hand.
1) Switch off the pump.
2) Get the air out by plunging again the
pump while in a tilted position, then shake
the pump.
3) Clean the hydraulic part.
4) Take off the hose and clean it.
1) Check voltage.
2) Remove the object.
3) Cool down the pump and start it up
again.
1) Check that the float switch has sufficient
space.
CHAP. 12 INFORMATION ON AIR-BORNE NOISE
The weighted sound pressure level A produced by the
electric pump working with liquids inside the pump body
does not exceed 70 dB (A) established by the
98/037/EEC.

DECLARATION CE OF CONFORMITY

We, SEA-LAND S.R.L.,
responsibility that our products here included, comply with
the directives 98/37/CE, 89/336/CE, 73/23/CE, EN 292-1,
EN 292-2, EN 60335-, EN 60335-2-41, EN 55014-1, EN
55014-2, EN 61000-3-2, EN 61000-3-3.
Attention!!! Failure to
instructions will render the guarantee invalid.
GB
declare under our own
comply with the a/m
13