Air Conditioner Care; Cleaning The Air Filter; Cleaning The Front Panel; Trouble Shooting - Amana AMA05KF Manual De Uso Y Cuidado

Your new air conditioner is designed to give you many years of
dependable service. This section tells you how to clean and care
for your air conditioner properly.

Cleaning the Air Filter

The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is
important for best cooling and operating efficiency. Be sure to
check the filter every two (2) weeks to see whether it needs
cleaning.
NOTE: Do not operate the air conditioner without the filter in
place.
A
A. Air filter
B. Front panel
Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.
Air Conditioner Will Not Operate
10
All manuals and user guides at all-guides.com

AIR CONDITIONER CARE

B

TROUBLE SHOOTING

1. Turn off the air conditioner.
2. Remove the air filter by opening the front panel and removing
the air filter.
3. Use a vacuum cleaner to clean air filter. If the air filter is very
dirty, wash it in warm water with a mild detergent. Do not
wash the air filter in the dishwasher or use any chemical
cleaners. Air dry the air filter completely before replacing to
ensure maximum efficiency.
4. Replace the air filter.
5. Close the front panel.
6. Turn on the air conditioner.

Cleaning the Front Panel

1. Turn off the air conditioner.
2. Clean the front panel with a soft, damp cloth.
3. Air dry the front panel completely.
4. Turn on the air conditioner.
■ The power supply cord is unplugged. Plug into a grounded
3 prong outlet. See "Electrical Requirements."
■ The power supply cord has tripped (Reset button has
popped out). Press and release RESET (listen for click; Reset
button will latch and on some devices, a green light will turn on)
to resume operation.
■
A household fuse has blown, or circuit breaker has
tripped. Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician. See "Electrical
Requirements."
■ The Power button has not been pressed or the Mode
control knob is turned to Off. Press POWER or turn the
Mode control knob to an active setting.
■
The local power has failed. Wait for power to be restored.