Art. 5143 R.f. Transmitter For 1 System (Handheld) - Mottura 5143 Manual De Instrucciones, Uso Y Mantenimiento

A . 5143 R.F. T
RT
LD
Using the transmitter ref. 5143 it is possible to control a single system. The factory settings are as follows:

buttons and

-
button stops the system.

button P2 activates the setting procedure.

the LED LD signals that the command has been sent.

Using this procedure the transmitter can be assigned to the system.
1. ONLY supply power to the system involved in the operation.
2. Press twice the P2 button.
3. Press once the
4. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
The activation commands sent by the transmitter can be inverted by means of the movement inversion
procedure.
1. ONLY supply power to the system involved in the operation.
2. Press twice the P2 button.
3. Press once the
4. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
Using this procedure, ref. 5143 can be assigned to a system that already has a transmitter memorized.
1. select the channel that activates the system in the transmitter already memorized.
2. Press twice the P2 button of the transmitter already memorized in the system.
3. Press once the P2 button of the ref. 5143 transmitter.
5. The system emits 3 beep. The transmitter is assigned.
Using this procedure the system "Impulses" function can be activated. When this function is activated the
system moves with an impulse when it receives a command of less than 2 sec. If it receives a command lasting
longer than this time, the system starts in continuous mode until it reaches the limit switch.
1. Press once the P2 button.
2. Press once the
3. Press once the
4. The system emits 3 beep. The system movement is by impulse.
5. To return to linear movement repeat from point 1
8
RANSMITTER FOR

-

M O T T U R A

activate the system.
A
SSIGNING TO A SYSTEM

button to turn the system clockwise.
I
NVERTING THE MOVEMENT

button to turn the system counter-clockwise.
A
SSIGNING TO A SYSTEM ALREADY PROGRAMMED
I
MPULSE FUNCTION

button.

button (ref. 1805M28B) or the P2 button (ref. 1805M35R – ref. 1805M45R).
1
SYSTEM
O
PERATING
Gb 2
(H )
ANDHELD
CR2450
battery