Operating; Assigning To A System; Inverting The Movement - Mottura 5143 Manual De Instrucciones, Uso Y Mantenimiento

R . 5155 - R. F. T
EF

M O T T U R A
Using the transmitters ref. 5155 up to 15 systems can be controlled individually and/or simultaneously. The
factory settings are as follows:
 
 buttons and
 
 buttons and
-
 button stops the system.
 button P2 activates the setting procedure.
 the Display shows the channel selected and that the command has been sent.
Using this procedure the transmitter can be assigned to the system.

1. Use the button or the
2. ONLY supply power to the system involved in the operation.
3. Press twice the P2 button.

4. Press once the
5. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
The activation commands sent by the transmitter can be inverted by means of the movement inversion
procedure.

1. Use the button or the
2. ONLY supply power to the system involved in the operation.
3. Press twice the P2 button.

4. Press once the
5. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
During the assigning procedure, the system is memorized in the transmitter also in the channel of Group "0".
Selecting the Channel "0", it's possible to simultaneously control all systems affiliated.
Note: You can't delete a system from Channel "0".
Using this procedure, ref. 5155 can be assigned to a system that already has a transmitter memorized.
1. Select the channel that activates the system in the transmitter already memorized.
2. Press twice the P2 button of the transmitter already memorized in the system.

3. Use the button or the
be assigned.
4. Press once the P2 button of the ref. 5155.
5. The system emits 3 beep. The transmitter is assigned.
RANSMITTER FOR
1
5

-


O
select the system to be activated.
activate the system.
A
SSIGNING TO A SYSTEM

button to select the channel number to which the system is to be assigned.
button to turn the system clockwise.
I
NVERTING THE MOVEMENT

button to select the channel number to which the system is to be assigned.
button to turn the system counter clockwise.
A
DDING SYSTEMS TO GROUP COMMANDS
A
SSIGNING TO A SYSTEM ALREADY PROGRAMMED

button of ref. 5155 to select the channel number to which the system is to
15
SYSTEMS
CR2450
battery
PERATING
Gb 3
(H )
ANDHELD
9