Using this procedure the system "Impulses" function can be activated. When this function is activated the
system moves with an impulse when it receives a command of less than 2 sec. If it receives a command lasting
longer than this time, the system starts in continuous mode until it reaches the limit switch.
1. Use the
button or the
2. Press once the P2 button.
3. Press once the
4. Press once the
5. The system emits 3 beep. The system movement is by impulse.
6. To return to linear movement repeat from point 1
R
EF
Using the transmitter ref. 5148 it is possible to control a single system. The factory settings are as follows:
buttons
and
-
button
stops the system.
button P2 activates the setting procedure.
the LED LD signals that the command has been sent.
Using this procedure the transmitter can be assigned to the system.
1. ONLY supply power to the system involved in the operation.
2. Press twice the P2 button.
3. Press once the
4. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
The activation commands sent by the transmitter can be inverted by means of the movement inversion procedure.
1. ONLY supply power to the system involved in the operation.
2. Press twice the P2 button.
3. Press once the
4. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
Using this procedure, ref. 5148 can be assigned to a system that already has a transmitter memorized.
1. select the channel that activates the system in the transmitter already memorized.
2. Press twice the P2 button of the transmitter already memorized in the system.
3. Press once the P2 button of the ref. 5148 transmitter.
4. The system emits 3 beep. The transmitter is assigned.
10
I
button to select the channel number of system to set the function.
button.
button (ref. 1805M28B) or the P2 button (ref. 1805M35R – ref. 1805M45R).
. 5148 - R. F. T
RANSMITTER FOR
LD
activate the system.
A
SSIGNING TO A SYSTEM
button to turn the system clockwise.
I
NVERTING THE MOVEMENT
button to turn the system counter-clockwise.
A
SSIGNING TO A SYSTEM ALREADY PROGRAMMED
MPULSE FUNCTION
1
O
PERATING
Gb 4
(W
)
SYSTEM
ALL
P2