Impulse Function; Operating; Assigning To A System; Inverting The Movement - Mottura 5143 Manual De Instrucciones, Uso Y Mantenimiento

Using this procedure the system "Impulses" function can be activated. When this function is activated the
system moves with an impulse when it receives a command of less than 2 sec. If it receives a command lasting
longer than this time, the system starts in continuous mode until it reaches the limit switch.
1. Press once the P2 button.

2. Press once the

3. Press once the
4. The system emits 3 beep. The system movement is by impulse.
5. To return to linear movement repeat from point 1
R . 5167 - R. F. T
EF
Using the transmitters ref. 5167 up to 15 systems can be controlled individually and/or simultaneously. The
factory settings are as follows:
+ -
 buttons and
 
 buttons and
 button STOP stops the system.
 button  activates the setting procedure.
 the Display shows the channel selected and that the command has been sent.
Using this procedure the transmitter can be assigned to the system.
+
1. Use the button or the
2. ONLY supply power to the system involved in the operation.
3. Press twice at the same time

4. Press the button once to turn the system clockwise.
5. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
The activation commands sent by the transmitter can be inverted by means of the movement inversion
procedure.
+
1. Use the button or the
2. ONLY supply power to the system involved in the operation.
3. Press twice at the same time

4. Press the button once to turn the system counter clockwise.
5. The system emits 3 beep. The transmitter is assigned.
During this procedure the time between two commands cannot be over 10 sec. If this time is higher, the
motor automatically exits of the procedure and he recovers the parameters previously set. This procedure
erase the transmitters memorised in the motor.
I
MPULSE FUNCTION
button.
button (ref. 1805M28B) or the P2 button (ref. 1805M35R – ref. 1805M45R).
RANSMITTER FOR
+

-
O
select the system to be activated.
activate the system.
A
SSIGNING TO A SYSTEM
-
button to select the channel number to which the system is to be assigned.
+
and  buttons.
I
NVERTING THE MOVEMENT
-
button to select the channel number to which the system is to be assigned.
+
and  buttons.
15
SYSTEMS
PERATING
Gb 5
(W )
ALL

STOP

11