Installation 2 - HAMPTON BAY 504091110 Guía De Uso Y Cuidado

installation 2

1
Open the fixture
□ Open the lens (A) from the fixture base (B) by screwdriver,
and disconnect the connector between PCB and the driver.
A
B
3
Fixing the fixture base (B)
□ Put the Gasket (EE) on the back of fixture base (B).
□ Connect the AC wires and the driver wires by wire nut (BB).
□ Mount the fixture base (B) into the j-box with fix screw (DD).
AC wires should go through one of the 5
note:
conduit entry holes on the fixture base (B)
BB
B
Conduit entry holes
Connector
.
DD
EE
2
Drilling out the holes
□ Drill out the mark points in the fixture base (B) according
with the mounted J-box holes.
B
4
Assemble the lamp cover
□ Assemble the lens (A) with the fixture base (B) after
connecting the connector of PCB and driver. Then tighten
with lens screws.
□ Apply silicone sealant (not included) between the fixture
and the wall.
B
A
B
5
Please contact 1-855-HD-HAMPTON for further assistance.
Mark points
Φ 0.2in.
(5mm)
Connector
Silicone sealant (not
included)
Lens screw
HAMPTONBAY.COM