Care And Service; Troubleshooting Guide; Technical Data; Remarques Générales - Kärcher WD 5 Manual De Instrucciones

The suction is activated automatically.
Illustration M
Note
Note the maximum connected load (see information on
the device socket).
Note
As soon as the power tool is switched on, the suction
turbine starts up with a 0.5 second delay. If the power
tool is switched off, the suction turbine continues to run
for approx. 5 seconds in order to suck in the residual dirt
in the suction hose.
Integrated filter cleaning system
Note
The filter cleaning system is designed for vacuuming
large quantities of fine dust without a filter bag inserted.
The filter cleaning system allows the soiled flat pleated
filter to be cleaned at the push of a button and the suc-
tion performance to be increased again.
 Place the handle of the suction hose in the designat-
ed parking position on the device head. Press the fil-
ter cleaning button three times with the device
switched on, waiting 4 seconds between the individ-
ual actuations.
Illustration P
Note
After pressing the filter cleaning button several times,
check the container for its filling volume. Otherwise dirt
can escape when the container is opened
Blower function
The blower function can be used to clean areas that are
difficult to reach or where vacuuming is not possible,
e.g. leaves in a gravel bed.
 Insert the suction hose into the blower connection.
The blower function is now activated.
Illustration Q
Interrupting operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Variant 1: Place the handle of the suction hose in the
intermediate parking position.
Variant 2: Attach the floor nozzle in the parking po-
sition.
Illustration R
Ending operation
1. Set the trigger to "0 OFF".
The device is switched off.
2. Pull out the mains plug.
3. Remove the device head.
Illustration B
4. Empty the container.
On the devices that have a drain screw, the contain-
er can be emptied via the drain screw.
Illustration S
5. Storage possibility:
Illustration Y
Note
The suction hose can be wrapped around the device
head and attached to the device head with the help of
the hose collar.
6. Store the device in a dry and frost-proof room.
10

Care and service

General care instructions
 Clean the device and plastic accessory parts with a
commonly available plastic cleaner.
 Rinse the container and accessories with water, as
necessary, and dry them before further use.
Clean the filter box / flat pleated filter
1. Unlock the filter box and fold it out.
Illustration T
2. Remove the filter box.
Illustration U
3. Empty the filter box into a waste container. In the
case of heavy soiling, tap the filter box against the
edge of the waste container. The flat pleated filter
does not have to be removed from the filter box.
Illustration V
If necessary, clean the flat pleated filter separately.
4. To do this, remove the flat pleated filter from the filter
box.
Illustration W
5. Clean the flat pleated filter under running water. Do
not rub or brush off.
Allow the flat pleated filter to dry completely before
reusing.
Illustration X
We recommend cleaning the flat pleated filter after each
use.

Troubleshooting guide

Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Declining suction performance
Accessories, the suction hose or the suction tubes are
clogged.
 Remove the clog with a suitable aid.
The filter bag is full
 Replace the filter bag.
The flat pleated filter is dirty.
 Clean the flat pleated filter (see Chapter Clean the
filter box / flat pleated filter).
The flat pleated filter is damaged.
 Replace the flat pleated filter.
Note
The technical data can be found on the type plate.
Remarques générales
Veuillez lire le présent le manuel d'ins-
tructions original et les consignes de sé-
curité jointes avant la première
utilisation de l'appareil. Suivez ces instructions.
Conservez les deux manuels pour une utilisation ulté-
rieure ou pour le propriétaire suivant.

Utilisation conforme

Utiliser l'appareil uniquement pour un usage ménager
privé.
L'appareil est destiné à être utilisé comme aspirateur
d'humidité et de poussières conformément aux descrip-
tions données dans le présent manuel d'utilisation et
aux consignes de sécurité.
Les cendres froides ne peuvent être aspirées qu'avec
des accessoires appropriés.
Français

Technical data