Using Audio/ Video In Jacks - Sanyo DS35520 Manual Del Propietário

QuickTips
Make sure all cable
connectors are fully
seated on jacks.
Always match cables
according to the
colors; for right
RED
audio, for left
WHITE
audio and for
YELLOW
video.
A/V1 and A/V2 jacks
have identical func-
tions. Any compatible
video equipment can
be connected to either
set of jacks.
A solid Blue screen
with the word Video1
or Video2 displayed
means that the Video
mode is selected, but
no signal is being
detected at the
Video jack. Check
connection, and
turn on external
equipment.
You may be able
to use the remote
control to operate
your VCR, DVD,
Cable Box, Satellite
Receiver, and TV.
(See pages 7~9.)
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
14
USING THE AUDIO/ VIDEO IN JACKS
CONNECTING A VCR OR OTHER EXTERNAL EQUIPMENT
Switch off TV and external equipment before connecting cables. (Cables are not supplied.)
1. Connect VCR, DVD, DSS, or other equipment's Audio Video Out to the TV Audio
Video Input .
For Mono VCR (Single Audio Jack) connect VCR Audio Out to TV Audio (L) Input.
Follow the same procedure to connect other compatible video equipment to the second
set of A/V jacks.
Optional
Connect VCR, DVD, or other equipment's S-Video Out to the TV S-Video In (AV1)
Jack .
Note: Using the S-Video In (AV1) jack overrides the Video 1 jack.
2. Press POWER
to turn on the TV. Turn on external equipment also.
3. Press the INPUT key
equipment you have connected to the A/V1 or A/V2 jacks.
Back View of a VCR
A/V JACKS
IN
VIDEO L- AUDIO -R
OUT
VIDEO L- AUDIO -R
AUDIO
OUTPUT
L
R
to select program source: TV signal or signal from the
VIDEO AUDIO INPUT
UHF/VHF/CATV
COMPONENT AV2 AV1
75Ω
S-VIDEO
VIDEO
Y
P (MONO)
b
L L
P
R AUDIO R
r
TV A/V In Rear Jacks
DVD Player
OUTPUT S-VIDEO OUT
L R
AUDIO OUT
VIDEO OUT
Remote Control
CABLE
VCR TV
DVD SAT AUX
POWER
INPUT RESET