Items Supplied - Hilti AG 6D-22-5 Manual De Instrucciones Original

• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3

Items supplied

Angle grinder, side handle, standard guard, front cover, clamping flange, clamping nut, wrench, operating
instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4 3D Active Torque Control (
The product has 3D Active Torque Control (
If it detects a sudden, unforeseen movement in operation, the product automatically shuts down immediately.
If ATC has tripped, switch the product off and then on again.
3D
3.5 Sens-Tech function
The product has the Sens-Tech function.
If the main grip is not fully enclosed by the operator's hand or if the main grip is released, the product shuts
down automatically. During operation, always hold the product securely with your hand enclosing the grip
surfaces of the main grip.
If the Sens-Tech has tripped, switch the product off and then on again.
3.6 Motor protection function
The motor protection function monitors current consumption and motor temperature and prevents the
product from overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the
product and then allow it to run under no load for approx. 30 seconds.
3.7 Integrated brake
The integrated brake reduces the time it takes until the accessory tool stops rotating after switching off.
This functions correctly only as long as the product is supplied with electric current.
Braking time varies, depending on the selected accessory tool.
3.8 Front cover 3
Use the standard guard with front cover for the applications listed below:
• Grinding with straight grinding discs
• Cutting with cut-off wheels
3.9 DC-EX 125/5"C compact dust hood for cutting (accessory)
Use the DC-EX 125/5"C compact hood when working on mineral materials and for the following jobs:
• Cutting with diamond cut-off wheels
Use of this guard for working on metal is not permissible.
The dust hood is suitable only for accessory tools with a diameter of max. 125 mm (5").
*2233922*
ATC )
3D
ATC).
3D
2
2233922
4
English 9