Intended Use; Items Supplied; Restart Interlock - Hilti AG 100-7 Manual De Instrucciones Original

▶ Dirty or dusty power tools that have been used frequently for work on conductive materials should be
checked at regular intervals at a Hilti Service Center. Dust (especially dust from conductive materials) or
dampness adhering to the surface of the tool may, under unfavorable conditions, lead to electric shock.
Using and handling power tools with care
▶ Secure the workpiece. A workpiece clamped in a vice or secured by some other clamping device is more
secure than when held only by hand.
▶ Switch the power tool off if the accessory tool sticks and stalls. The power tool may be deflected laterally.
▶ Wait until the power tool stops completely before you lay it down.
▶ Switch the electric tool off and unplug the supply cord in the event of an interruption in the electric supply
in order to avoid inadvertent restarting when the power returns.
▶ Grinding discs must be stored and handled carefully in accordance with the manufacturer's instructions.
▶ Have the tool checked by Hilti Service after breakage of a disc, if the tool has been dropped or has
fallen, or in the event of other mechanical damage.
3 Description
3.1 Overview of the product
Spindle lockbutton
@
Steadying rib
;
On/off switch
=
Side handle
%
Threaded bushing for the side handle
&
Keyed locating lug
(
Spindle
)
Adjusting screw
+

3.2 Intended use

The product described is a hand-held electrically powered angle grinder. It is designed to be used for cutting
and grinding metals and mineral materials. It may used only for dry cutting / grinding.
The tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type plate.
• The power tool may be used for cutting, slitting and grinding mineral materials only when equipped with
the corresponding guard (optional accessory).
• It is recommended that a dust removal system consisting of matched components, i.e. dust removal
hood and a suitable Hilti vacuum cleaner, are used for working on mineral materials such as concrete or
stone. These protect the operator and increase the life of the power tool and accessory tools used.

3.3 Items supplied

Angle grinder, side handle, standard guard, front cover, clamping flange, clamping nut, wrench, operating
instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com

3.4 Restart interlock

The power tool does not restart by itself when the on/off switch is locked in the on-position and the power
returns after an interruption in the electric supply. The on/off switch must first be released and then pressed
again to restart.
3.5 DG-EX 100/4" or DG-EX 115/4.5" (accessory) dust hood for grinding
The grinding system is suitable only for occasional use with diamond cup wheels for grinding mineral
materials.
CAUTION Use of this hood for working on metal is prohibited.
3.6 DC-EX 100/4" C dust hood for cutting or DC-EX 115/4,5" C compact hood (accessory)
Use the compact hood when cutting masonry and concrete.
CAUTION Use of this hood for working on metal is prohibited.
20
1
Clamping lever
§
Clamping flange
/
Clamping nut
:
Switch-on interlock release button
∙
Standard guard
$
Abrasive cutting disc / abrasive grinding
£
disc
Wrench
|
2
3