Troubleshooting - Oreck ProShield Plus Guia Del Usuario

Trouble-
Service problems that appear to be major can often be solved
easily. You can be your own troubleshooter by reviewing this guide.
shooting
All other servicing should be done by an Oreck authorized
service center.
Problem
Unit does not • Power Cord
turn ON.
• Selector Switch
• Top Cover
• ALCI Plug
Truman Cell Truman Cell
®
light has turned
solid red.
Truman Cell Truman Cell
®
light is
blinking red.
Unit does Truman Cell
not reduce
particles.
Unit sparks, Truman Cell
crackles and
pops.
Unit still does Review all the
not operate above.
properly.
11
All manuals and user guides at all-guides.com
Check
• Plug in Power Cord
• Set Selector Switch for desired blower
speed.
• Make sure the top cover is securely closed
• Press the red reset button each time you
plug in the ALCI safety device.
• A solid red light is a 30 day cleaning
®
reminder. Wash Truman Cell
it is thoroughly clean before reinstalling.
• A fast blinking light indicates the power
®
supply has shut down due to arcing or
short circuit. The cell should be inspected
and cleaned, repaired, or replaced.
• A slow blinking light indicates the unit is
in Dry Mode.
• Clean the Truman Cell
®
• Truman Cell
Oreck for service.
• Sparking or popping noise (arcing) can
®
occur when a large particle is captured
in the Truman Cell
excessively, the cell may be dirty. Try
cleaning the Truman Cell
• If excessive arcing continues after proper
cleaning, the Truman Cell
damaged. If damaged, contact Oreck for
service.
Contact Oreck for service.
Solution
. Make sure
®
.
®
may be damaged. Contact
®
. If the unit is arcing
®
.
®
may be
®