Troubleshooting - Oreck AIRP Serie Manual De Instrucciones

Trouble-
shooting
Service problems that
appear to be major can
often be solved easily.
You can be your own
troubleshooter by
reviewing this guide.
All other servicing
should be done by an
Oreck authorized
service center.
E N
P P r r o o b b l l e e m m
Unit does not turn on.
"Check Collector Cell"
has turned red.
"Check Collector Cell"
light is flashing red.
Unit does not
remove pollutants.
Unit sparks, crackles
and pops.
"Check Odor Absorber"
light has turned red.
Does not remove odor.
Unit still does not
operate properly.
G L I S H
C C h h e e c c k k W W h h a a t t t t o o d d o o
• Power Cord • Plug in the power cord.
• Power Button • Set power button for desired
• Front Grill • Reinsert front grill, sliding right until
• Top Cover • Top cover should be replaced and
• Collector Cell • Wash collector cell. Make sure it is
• Hold down the Air Revitalizer button
• Collector Cell • Collector cell may need cleaning.
• Collector cell may not be completely
• Collector cell may be damaged.
• Collector Cell • Wash collector cell. Make sure it is
• Collector Cell • Sparking or popping noise (arcing)
• If the unit is arcing excessively, the
• If excessive arcing continues after
• Odor Absorber • Hold down the Night Light button
• Replace odor absorber if desired.
• If the odor absorber is not replaced,
• Odor Absorber • Vacuum odor absorber with a soft
• Replace odor absorber if desired.
• Check all the • Contact Oreck for service.
above points.
11
blower speed.
it locks into place.
slid back to lock.
thoroughly clean and dry before
reinstalling.
until the light blinks three times to
reset the timer after cleaning.
Clean collector cell.
dry. Allow it to air dry longer.
Contact Oreck for service.
thoroughly clean and dry before
reinstalling.
occurs when a large particle is
captured in the collector cell.
collector cell may be dirty. Try
cleaning the collector cell.
proper cleaning, the cell may be
damaged or wet. If damaged contact
Oreck for service.
until the light blinks three times to
reset the Check Odor Absorber
timer after replacing.
remove old odor absorber to turn off
"Check Odor Absorber" light.
brush attachment if dirty. Do not
use any liquids to clean the odor
absorber.