Residual Risk; Technical Data And Components; Proper Use; Cleaning And Maintenance - Spencer WIV Instrucciones De Uso

service.
• Qualified personnel must be present during use of the device.
• The device must be used by personnel competent in infusions.
• The device must not be exposed, much less come into contact with thermal sources of combustion or flammable agents.
• Only use the device as described in this manual.
• Always check the conditions of all parts before use.
• Users must be able to assess the patient's condition, evaluating whether use of the device is appropriate in relation to the patient's clinical status. .
7.

RESIDUAL RISK

No residual risks are identified, i.e. risks that could arise despite compliance with all the warnings in this user manual.
8.

TECHNICAL DATA AND COMPONENTS

1
WIV
2
Dimensions
Length of pressure gauge tube
IT
Length of inflation tube
Pressure gauge scale
9.

PROPER USE

EN
1- Insert the venous infusion bag into the pump. A slot at the top allows the device to be hung.
2- Repeatedly compress the bulb until the desired pressure is obtained, which can be read on the pressure gauge graduated with millimetres in mercury (mmHg).
3- Vary the pressure applied by the venous infusion bag using the bulb (to increase it) or the vent valve (to decrease it).

10. CLEANING AND MAINTENANCE

DE

10.1 CLEANING

Failure to carry out the correct cleaning operations could increase the risk of cross-infection due to presence of body fluids and/or residues.
The operator must wear suitable personal protective equipment, such as gloves, goggles, etc. during all checking and cleaning operations.
FR
The subministration bag must not be immersed in water. Wash with a damp sponge and neutral soap. Never use solvents or stain removers. If disinfecting, use products that
do not have a solvent or corrosive action on materials constituting the device.
Then remove all traces of detergent, which could deteriorate it or compromise its conditions and durability.
Let dry completely before storing. Drying after washing or after use in a wet environment must be natural and not forced. Do not use flames or other direct heat sources.

10.2 MAINTENANCE

ES
Routine maintenance is the responsibility of the user, who must carry out checks before and after each use and in any case at least every 3 months:
• General functionality of the device
• Cleanliness of the device (remember that the failure of cleaning may cause the risk of cross infections)
• Presence of cuts, holes, abrasions
PT
• Bulb conditions
• Inflation bulb seal
• Pressure gauge conditions and functionality
• Fulfilment of the requirements of the user manual in section Warnings and Specific Warnings and fulfilment of the requirements of the manual in section on Proper use.
No periodic overhaul is foreseen for the device.
EL

10.3 LIFE SPAN

The device, if used as described in the following instructions, has a life span of 5 years from the date of purchase. Beyond this time, the device must be disposed of.

11. TROUBLESHOOTING TABLE

RO
PROBLEM
The device does not inflate.
Device deflates.
If a problem or fault is detected that does not correspond to the above, please contact Spencer Italia srl customer care service.

12. ACCESSORIES

There are no accessories for this device.

13. SPARE PARTS

There are no spare parts for this device.
8
PARTS DESCRIPTION AND MATERIALS
Subministration bag body
1 Made of nylon with a reinforced transparent PVC window, it incorporates an inflatable chamber to
5
pressurise the bag placed inside the device.
Pressure gauge
2
Covered by a silicone protection to protect it from impact, it displays the pressure exerted on the bag.
Insufflation bulb
3
Made of PVC; when pressed repeatedly, it pressurises the inflatable chamber inside the bag.
Control valve
4
Made of chrome-plated brass; when unscrewed, it acts as a vent allowing the chamber to be depressurised.
4
Hook
5
Made of nylon, allows the bag to be hung on the stand.
3
370x180 ± 10mm
190 ± 10mm
190 ± 10mm
0-300 mmHg
Division every 2 mmhg
CAUSE
Vent valve open.
Possible leakage.
Maximum applicable pressure
Pressure gauge diameter
Materials
Weight
REMEDY
Close the vent valve on the bulb.
Remove the device from service and contact customer service.
250 mmHg
50 mm
Nylon, PVC, Al, Chrome-plated brass
320 ± 20g