Adjust The Print Alignment And Color Density; Check The Ribbon Remaining - Rimage Professional 3400 Guia Del Usuario

c. To modify only Standard Area settings, select the Standard radio button.
i. Enter the desired Outer Diameter.
ii. Enter the desired Inner Diameter.
d. To print on a disc with a stacking ring, select the Advanced radio button. The Hub Area settings display.
i. Enter the desired Outer Diameter for the hub.
ii. Enter the desired Inner Diameter for the hub.
e. Select OK to save the changes. The Printable Area Settings window closes.
4. When you have made the desired choices in the Rimage Everest 400 Printing Preferences window, select Apply.
5. Select OK to close the Rimage Everest 400 Printing Preferences window. Adjust the Print Alignment and
Color Density.

Adjust the Print Alignment and Color Density

1. Access printing preferences. Refer to page 23 for instructions.
2. Select the Utility tab.
3. Select Status Monitor... button. The Rimage Everest 400 Status Monitor window opens with the Status tab active.
Tip: On the Status tab, you can view the progress of a print job, the type of print ribbon installed, and the
estimated percentages of unused ribbon for the print and retransfer ribbons.
4. Select the Printer Information tab to view or change the Print Alignment and Color Density settings, or view the Everest
400 Printer Status.
Tip: The Printer Information tab also displays the current firmware version and serial number of your Everest 400
printer.
a. View or change the Print Alignment Settings.
i. From the Print Alignment Settings pane, select the Modify button. The Print Alignment Settings dialog opens.
ii. Select the desired Color/Monochrome setting to modify the horizontal alignment for all ribbon types.
iii. Select the desired Color setting to modify the vertical alignment for prints with a CMY ribbon.
iv. Select the desired Monochrome setting to modify the vertical alignment for prints with a monochrome ribbon.
v. Select OK to save the changes. The Print Alignment Settings window closes.
b. View or change the Color Density Settings.
i. From the Color Density Settings pane, select the Modify button. The Color Density Settings dialog opens.
ii. Select the desired Cyan, Magenta and Yellow settings to modify the color density.
iii. Select the desired Black setting to modify the density for monochrome images.
iv. Select OK to save your changes. The Color Density Settings window closes.
5. Select Close to close the Status Monitor dialog box.
6. Select OK to close the Rimage Everest 400 Printing Preferences window.

Check the Ribbon Remaining

The operator panel on the front of the 3400 and 5400N displays the estimated number of prints remaining on the print
ribbon and the retransfer ribbon.
2001431_B
All manuals and user guides at all-guides.com
25