Clean The Everest 400 Printer; Clean The Print Head - Rimage Professional 3400 Guia Del Usuario

Clean the Everest 400 Printer

Regular cleaning helps to keep your Everest 400 printer in optimal operating condition.

Clean the Print Head

# Tools required:
• Sponge swabs with long handles (included in the Everest cleaning kit)
• 99% Isopropyl alcohol
1. Access the print head.
a. Lift the printer cover latch to open
the cover.
b. Lower the printer cover.
c. Turn the center latch
counterclockwise to unlock it.
d. Remove the print ribbon carrier.
-
Important! The ribbon carriers
cannot be removed from the
printer unless the system is
powered on.
2. Clean the print head.
n
Caution! Do not scratch the print head. Remember the following tips:
• Always wipe from one end of the print head to the other without stopping in the middle.
• Only wipe the area indicated.
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to wipe across the print head from one end to the other in the direction shown below.
 Note: Do not remove the print head component from the inside of the printer. The component is shown
outside of the printer for instructional purposes only.
c. Repeat as needed until the print head is clean of dust and debris.
d. Use the sponge swab to remove any waxy buildup from the roller below the print head.
Print Head
2001431_B
All manuals and user guides at all-guides.com
Print Ribbon
Carrier
Area to Clean
Center Latch
Wipe Direction
Roller
37