Label Design Requirements; Print Requirements - Rimage Professional 3400 Guia Del Usuario

Rimage Professional 3400 and 5400N User Guide

Label Design Requirements

The Rimage Windows-compatible software ships with the CD Designer™ label editor. CD Designer is installed on the
embedded or non-embedded PC during a typical installation of the Rimage software and is used for designing labels for
printing with the integrated Everest 400 printer. CD Designer can be used to design labels on any Windows-based PC.
• Label design size – Design labels with a height of 12 cm and width of 12 cm. A full-size disc is 120 mm (4.723") in
diameter. The hole is 15 mm (0.59") The printable area and hub sizes vary depending on the disc manufacturer.
 Note: The media that are in Rimage Media Kits have a printable area of 118-24 mm. On most labels, print settings
of 118 mm and 24 mm are recommended.
Printable
Area 118 mm
• File format – For best results, save your labels as JPEG or TIFF files. However, these file formats must be imported into
CD Designer and saved as CD Designer files (.btw) or converted to PDF files before printing.
• Color mode – Convert all labels to the RGB color mode in order to import them into CD Designer.
• Resolution (pixels per inch) – For best results, use images set to a minimum of 300 pixels per inch. You may notice
better results if you use images with 600 pixels per inch or higher.

Print Requirements

Any label you create and save through CD Designer is in the correct file format (.btw) for printing to the integrated Everest
400 in the 3400 and 5400N system. You can also print labels saved as PDF files.
14
All manuals and user guides at all-guides.com
Hub Size
24 mm
2001431_B