EINHELL TE-TC 18/115 Li-Solo Manual De Instrucciones Original página 21

point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Anl_TE_TC_18_115_Li_SPK13.indb 21 Anl_TE_TC_18_115_Li_SPK13.indb 21
GB
9. Operation
9.1 Filling the water container/draining the
water (Fig. 3,11,12)
•
Remove the water container cover (6) (Fig. 3).
•
Fill water into the water container (5) up to the
"MAX" mark (Fig. 11).
•
Screw out the water drain screw (11) in order
to let the water out of the water container (Fig.
12).
Important! Keep a constant check on the wa-
ter level
9.2 Inserting/removing the battery (Fig. 9)
•
Open the battery compartment cover (23) and
insert the battery (21) into the battery mount
(24).
•
Press and hold the battery catch (22) in order
to remove the battery again from the battery
mount.
9.3 On/Off switch (Fig. 1)
•
You can switch on the tile cutting machine by
flipping up the switch (12).
•
To switch off the tile cutting machine again,
you must flip down the switch.
9.4 Even cut (Fig. 13)
•
Set the cutting width with the parallel stop (2)
and secure the stop with the fastening clasps
(10).
•
The width of the workpiece can be read off
the scale (16).
•
Fig. 13 shows the correct position for your
hands during the even cut. The feed rate must
not exceed the cutting capacity of the cutting
wheel. This is to make sure that no material
becomes detached, as this might cause acci-
dents or injuries.
9.5 Angle setting for miter cut (Fig. 14a,14b)
•
Fasten the water container cover (6) for the
45° miter cut (jolly) in the top position (Fig.
14a).
•
Fasten the water container cover for the 22.5°
miter cut in the bottom position (Fig. 14b).
9.6 Miter cut (22.5°; 45°) (Fig. 14a,14b,15)
•
Fasten the water container cover (6) in the re-
quired angle position (see section 9.5 "Angle
setting for miter cut") (Fig. 14a, 14b).
•
Fasten the parallel stop by means of the faste-
ning clasps (10) as shown in Fig. 15.
- 21 -
12.08.2021 16:47:07 12.08.2021 16:47:07