In Case Of A Power Failure; Surface Burners - Cafe C2Y366 Manual Del Propietário

Using the Range

IN CASE OF A POWER FAILURE

In the event of a power failure, the oven is inoperable
and no attempt should be made to operate it. However,
extreme caution, hold a lit match near the ports beneath

SURFACE BURNERS

Lighting a Surface Burner
WARNING
Burners should be operated only
when covered by cookware. Burner flames not
covered by cookware present a risk of fire or
clothing ignition. Never let flames extend beyond the
sides of the cookware. Failure to comply may result
in serious injury.
Make sure all burners are in their correct locations and
fully assembled before attempting to operate any burner.
Select a burner and find its control knob. Push the knob
in and turn it to the LITE position.
Selecting a Flame Size
Watch the flame, not the knob, as you adjust heat. When
rapid heating is desired, the flame size should match the
size of the cookware you are using. Flames larger than
the bottom of the cookware will not heat faster and may
be hazardous.
Using the Surface Burners
NOTES:
time without cookware on the grate. The finish on
the grate may discolor or chip without cookware to
absorb the heat.
burner is on. Damage to the product may occur.
place your hand, a pot holder or cleaning materials
on them.
10
the surface burner cap, then slowly turn the knob to the
LITE position. Once lit, surface burners will continue to
operate normally.
the sound of the electric spark
igniting the burner. When one
burner is turned to LITE, all
burners will spark. Sparking will
continue as long as the knob
remains at LITE. Once gas is
ignited, turn the knob to adjust
the flame size.
Automatic Reignition
The burners on this range will automatically relight if the
flame goes out.
These flames are too large for the pot
Your rangetop has sealed gas burners that offer
convenience, cleanability and flexibility for a wide range
of cooking applications.
Push the control knob in and
turn it to the LITE position.
49-2000660 Rev. 3