Remington MB450 Manual Del Usuario página 10

ENGLISH
REPLACING THE CUTTER ASSEMBLY
Hold the trimmer in one hand. With your other hand, insert the lower part of the cutter
assembly into the trimmer, push down the cutter until firmly attached.
REPLACING THE TRIMMER COMB
Hold the trimmer in one hand with your thumb firmly on the zoom wheel to keep it from
turning. (DIAGRAM C)
Ensure that the length position indicator is at 1.
Slide the comb/shaver down the grooves until it clicks into place.
Note: The trimmer comb attachment can only be placed on the trimmer one way; if it
does not fit properly remove and reverse it.
Tips for best results
Beard, moustache and sideburn hairs should be dry.
Avoid using lotions before using your trimmer. Comb your hair in the direction that it
grows.
Remove trimmer comb attachment if you are: defining hairline edges such as sideburns,
trimming the nape of your neck, trimming your beard line on front of neck.
CARE FOR YOUR TRIMMER
CLEANING AND MAINTAINING YOUR TRIMMER
Care for your trimmer to ensure a long lasting performance. Your trimmer is fitted with
high-quality, cutting blades that are permanently lubricated. Cleaning should be done with a
soft brush.
After each use
Turn the trimmer off.
Remove trimmer comb attachment and cutter assembly.
Gently brush the remaining hairs away from the trimmer comb and trimmer blade.
Do not rinse the cutter assembly under water.
POP-UP TRIMMER
Remove the trimmer comp attachment
Slide up the pop-up trimmer into operating position (DIAGRAM F)
Brush hair from the trimmer blades and the surrounding area.
CLEANING CAUTIONS
Only the trimmer comb attachment and trimmer blade may be removed from the product
for cleaning.
Cleaning should be done with a soft brush, such as the brush supplied with the product.
This trimmer is not washable. Do not rinse under water.
Do not use harsh or corrosive cleaners on the units or their blades.
Do not submerge in water as damage will occur.
4
Эта инструкция скачана с сайта www.remington-shop.ru