Storage; Environmental Protection; Maintenance Chart - EMAK Oleo-Mac Gi 44 Manual De Uso Y Mantenimiento

GB
Please note that the following maintenance intervals apply for normal operating conditions
only. If your daily work requires longer than normal or harsh cutting conditions are present the
suggested intervals should be shortened accordingly.
Complete Machine
Checks: operating switch
Blade
Blade stop
All Accessible Screws and Nuts
Cable connecting the safety button and the motor
Grass catcher and rear deflector

9. STORAGE

WARNING! Also read the battery and battery charger
instruction and maintenance manual!
WARNING! Before performing any cleaning or repair
procedures, stop the motor, disconnect the battery
and disconnect the safety plug (9, Fig.2).
Clean the bottom part of the machine after each use,
but never do so using jets of water.
- Check the good condition of the mower.
- Keep all nuts, screws and bolts tight.
- Put some grease or oil on parts subject to rust.
- Store the mower in a dry place, possibly on a cement floor;
protect against humidity by putting under it some boards
or a plate.
- The procedures for returning the machine to service
following winter storage are the same as for starting up
during everyday use (page 17).
WARNING! Allow the motor to cool before stowing
away the lawnmower!

ENVIRONMENTAL PROTECTION

Environmental protec tion should be a priorit y of
considerable importance when using the machine, for the
benefit of both social cohesion and the environment in
which we live.
- Try not to cause any disturbance to the surrounding area.
- Scrupulously comply with local regulations and provisions
for the disposal of oils, petrol, batteries, filters, deteriorated
20

MAINTENANCE CHART

Inspect for: cracks and wear
Check Operation
Inspect (Damage, and Wear)
Replace
Check operation
Inspect - Retighten
Inspect (Damage, and Wear)
Replace
Check for wear and damage
parts or any elements which have a strong impact on the
environment. This waste must not be disposed of as normal
waste, it must be separated and taken to specified waste
disposal centres where the material will be recycled.
Demolition and disposal
When the machine reaches the end of its service life, do not
dispose of it into the environment; instead take it to a waste
disposal centre.
Most materials used in the manufacture of the machine are
recyclable; all metals (steel, aluminium, brass) can be
delivered to a normal recycling station. For information
contact your local waste recycling service. Waste disposal
must be carried out with respect for the environment,
avoiding soil, air and water pollution.
WARNING! Dispose of the batteries separately from
the machine!
In all cases, applicable local legislation must be complied
with.
WARNING! Also read the battery and battery charger
instruction and maintenance manual!
Autogoods "130"
X X
X X
X X
X
X
X
X
X
X X