Using The Cooktop; Cooking Areas; Hot Surface Indicator; Using The Cooktop Elements - LG UPSE3024ST Manual Del Propietário

Using the Cooktop

Cooking Areas

The cooking areas on your range are identified by
permanent circles on the glass cooktop surface.
For the most efficient cooking, fit the pan size to the
element size.
Pans should not extend more than
beyond the cooking area.
When a control is turned on, a glow can be seen
through the glass cooktop surface. The element
cycles on and off to maintain the preset heat
setting, even on Hi.
WARM
SINGLE
ZONE
DUAL
NOTE
• It is normal to see a very faint red ring around
WARM
the outer edge of a dual or triple element
SINGLE
ZONE
when using it as a single element at a high
heat setting. This is only a reflection from the
bright glow of the center element and is not a
DUAL
malfunction.

Hot Surface Indicator

The hot surface indicator light glows as long as any
surface cooking area is too hot to touch.
It remains on after the element is turned off and until
the surface has cooled to approximately 150 °F.
CAUTION
It is normal for the surface elements to cycle on
and off during cooking, even on higher settings.
This will happen more frequently if cooking on a
lower temperature setting.
All manuals and user guides at all-guides.com
/ to 1-inch
1
2
WARM
SINGLE SINGLE
ZONE
TRIPLE DUAL DUAL
SINGLE
SINGLE

Using the Cooktop Elements

CAUTION
• Only use cookware and dishes that are safe for
oven and cooktop use.
• Always use oven mitts when removing food
from the cooktop and oven.
• Do not place sealed containers on the cooktop.
• Do not use plastic wrap to cover food while on
the cooktop. Plastic may melt onto the surface
and be very difficult to remove.
• Never leave food on the cooktop
unattended. Spillovers can cause smoke.
Greasy spillovers may catch on fire.
• The surface element may appear to have
SINGLE
cooled after it has been turned off. The element
may still be hot and touching the element before
it has cooled sufficiently can cause burns.
Turning on a Single element
1
Push the Single element knob in.
2
Turn the knob in either direction to the desired
setting.
The control knob clicks when it is positioned at
both Off and Hi.
Single
Off
NOTE
• Hi is the highest temperature available.
• Lo is the lowest temperature available.
OPERATION 25
On