Blower Operation; Emptying The Collection Tank - Uline VACMASTER H-9464 Manual Del Usuario

WARNING! Always wear safety goggles
complying with ANSI Z87.1 (or in Canada,
CSA Z94.3) before using blower.
WARNING! Keep bystanders clear from blowing
debris.
WARNING! Wear a dust mask if blowing creates
dust that might be inhaled.
1. Verify that the power cord is
disconnected from outlet.
(See Figure 25)
2. Ensure collection tank is empty
before using as a blower.
3. Remove hose from vacuum
port. Remove noise diffuser from
blower port.
4. Insert larger end of hose into
blower port on back side of
power head and lock into place.
(See Figure 26)
5. Fit the desired attachment to the
hose. (See Figure 27)

EMPTYING THE COLLECTION TANK

1. Verify that power cord is
disconnected from outlet.
(See Figure 32)
PAGE 7 OF 30

BLOWER OPERATION

6. Verify that the switch is in the off
Figure 25
7.
8. Once blowing is complete, flip
Figure 26
Figure 27
MAINTENANCE
2. Disconnect hose from vacuum.
Figure 32
3. Undo latches and remove power
position before plugging the
power cord into the outlet.
(See Figures 28-29)
Before turning on the vacuum,
firmly hold the loose end of hose.
Turn motor on by flipping the
switch to the on position.
(See Figure 30)
switch to the off position and
unplug power cord from the
outlet. (See Figure 31)
(See Figure 33)
head from collection tank.
(See Figure 34) Place power head
upside down on a soft, clean
surface.
Figure 28
Figure 29
Figure 30
Figure 31
Figure 33
Figure 34
0821 IH-9464