Wet Vacuum Operation - Uline VACMASTER H-9464 Manual Del Usuario

4. Turn motor on by flipping the
switch to the on position and
begin vacuuming. (See Figure 19)
BEFORE VACUUMING
WARNING! Do not vacuum in areas with
flammable gases, vapors or explosive dusts
in the air. Flammable gases or vapors include,
but are not limited to, lighter fluid, solvent type
cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include, but are
not limited to, coal, magnesium, grain or gun
powder. To reduce the risk of health hazards
from vapors or dust, do not vacuum toxic
materials.
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 20) Ensure collection
tank is clean and free from dust
and dirt.
2. Remove cartridge filter, then
carefully install the foam wet filter
over the filter cage and place the power head back
on the collection tank.
NOTE: Do not use the cartridge filter for liquid
vacuuming.
3. Fit the desired nozzle to the
vacuum hose. (See Figure 21)
4. Verify that the power switch is in
the off position before plugging
the power cord into the outlet.
(See Figure 22)
PAGE 6 OF 30
DRY VACUUM OPERATION CONTINUED
Figure 19
LIQUID VACUUM OPERATION
Figure 20
Figure 21
Figure 22
5. Once vacuuming is completed, flip the switch to
the off position and unplug the power cord from the
outlet.
WARNING! Do not use the cartridge filter or dust
bag for liquid vacuuming.

WET VACUUM OPERATION

1. Turn the motor on by flipping
switch to the on position.
(See Figure 23)
2. Once vacuuming is completed,
flip the switch to the off position
and unplug the power cord from
the outlet.
3. After use, empty the collection
tank by unscrewing the drain
cap. Drain liquids into a
suitable receptacle or drain.
(See Figure 24) Remember to refit
the drain cap to the collection
tank.
IMPORTANT! When vacuuming large quantities
of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip
of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops
the suction action when the collection tank
reaches its maximum capacity. An increase
in motor speed may take place. When this
happens, turn off the machine, disconnect
from outlet and drain the liquid into a suitable
receptacle or drain. To continue vacuuming,
refit the collection tank with the drain cap.
After wet vacuuming, turn the machine off and
remove plug from outlet. Empty the collection
tank, clean and dry the inside and outside
before storage.
NOTE: The foam filter must be removed after
wet vacuuming and a cartridge filter must be
installed before dry vacuuming again.
Figure 23
Figure 24
0821 IH-9464