Removing The Battery - Hilti SR 6-22 Manual De Instrucciones Original

5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fitting the scaffold hook
▶ Secure the scaffold hook with the screw supplied.
5.5 Fall arrest 3
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
5.6 Inserting the saw blade
Use only saw blades with a 1/2" connection end.
1. Check that the connection end of the accessory tool is clean and lightly greased. Clean and grease the
connection end if necessary.
2. Push the locking lever up as far as it will go and hold it in this position.
3. Push the saw blade into the blade holder from in front of the tool.
4. Allow the locking lever to return to its original position.
5. Grip and pull the saw blade to check that it is locked in position.
5.7 Installing the dust removal adapter (accessory)
1. Press the release button for the contact shoe.
2. Pull the contact shoe out.
3. Set the dust removal adapter on the contact shoe mount.
4. Press the release button for the contact shoe.
5. Insert the lightly greased contact shoe fully into the guide.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Sawing 6
1. Hold the saw by the grips provided for the purpose.
2. Guide the saw with the contact shoe to the workpiece.
*2243125*
2
4
2243125
5
English 9