Preparations At The Workplace; Charging The Battery; Inserting The Battery; Removing The Battery - Hilti NURON SB 4-22 Manual De Instrucciones

Vibration emission value for cutting in
wood (ah,CW)
Uncertainty (K)
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 19
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release button.
2. Remove the battery from the product.
5.4 Inserting/changing the bandsaw blade
WARNING
Risk of damage An unsuitable or incorrectly fitted bandsaw blade can damage the saw.
▶ Use only bandsaw blades that are suitable for this saw.
▶ Be sure to install the bandsaw blade right way round for the direction of travel.
WARNING
Risk of injury by the bandsaw blade. The bandsaw blade is sharp-edged and under certain circumstances
it can snap.
▶ Wear protective gloves and eye protection when installing the bandsaw blade.
1. Slacken the 2 screws securing the blade cover and remove the cover.
2. Turn the side handle counterclockwise to unscrew it from the casing of the bandsaw.
3. Pivot the clamping lever through 180 ° in the direction of rotation until it is seated against the stop.
The side handle has to be removed to allow the clamping lever to pivot.
4. Slip the bandsaw blade into the cutting guide and into the blade guides, one after the other. The back of
the blade must touch the bearings in the bottom of the blade guides.
▶ Note the direction of rotation indicator arrows on the bandsaw blade and the bandsaw. They must
point in the same direction.
22 English
B 22­255 1.6 m/s²
1.5 m/s²
2
2289590
*2289590*