Operation; Using Different Attachments - Silvercrest HG02019 Traducción Del Manual De Instrucciones Original

Operation

 
S et the speed control
or removing an attachment.
 
U se light pressure to install the desired attachment onto the
shaft of the hand-held unit
9
 
S et the speed control
the product along with the LED
CAUTION! Always begin with the lowest speed and only
increase the speed if necessary.
Now begin using the product.
 
S et the speed control
product off.
 
R emove the attachment from the shaft
unit when finished or to use a different attachment.
7
Note: If the performance of the product decreases, the bat-
teries are drained. Promptly replace these with the same type
batteries.
 
A pply moisturiser to the treated area after every use.
Note: Do not use the product more than 20 minutes at a
time. After 20 minutes, stop using the product for 15 minutes.
Note: Always grind from the outside of the nail toward the
tip! Regularly check the result during use. If you notice bother-
some skin reactions, stop immediately.

Using different attachments

 
P lease select the attachments with care. Improper use may
result in injuries.
to the „0" position before installing
8
.
7
to the „I" or „II" position to switch on
8
.
10
to the „0" position to switch the
8
of the hand-held
9
GB/MT 69