Qlima SM52 MULTI Manual De Instalación página 70

Mounting screw
ST3.9×25-C-H
G
ATTENTION
This illustration is for explanation and indication purposes only. The illustration may be different
from the air conditioner you purchased.
3. ACTIVITIES FOR INSTALLING THE AIR CONDITIONER
a. Determine the location where the interior units and exterior unit can be installed. See chapter 5 and 6.
b. Mount the mounting plate of the interior unit. See chapter 7.1.
c. Drill a hole to outside that the lines can be fed through. See chapter 7.2.
d. Hang the interior unit, by the hooks on the back, on the top hooks of the mounting plate and check
that it is securely mounted. Do not click the bottom hooks in yet.
G
CAUTION
if the piping is exiting the unit behind on the right then the piping must be fed through the
drilled hole at the same time as hanging the interior unit.
e. Feed the piping, the power cable and the condensation hose through the hole in the wall.
4
70 70
3 2
Air-break
Switch
Remote
controller
holder
Installation
plate
Clip anchor
Refrigerant
pipe
Remote
controller
holder
(2)
Mounting screw
ST3.9×25-C-H
Installation plate
Clip anchor
Air-break Switch
2
5 4 3
(1)
Figure 1
1
1
Drainage
Pipe
Outdoor Unit
Power Cable
The maximum
amount of the
connection cables is 5.
This section is for
reference only.