Lenco LUCILLE Manual De Instrucciones página 5

 Programme Type: This describes the style of the programme being broadcast.
 Signal Strength: This setting will display a signal strength bar graph. The longer the bar graph, the
stronger the signal. Setting the display to show signal strength is useful when setting up the aerial for
the strongest signal.
 Multiplex name: DAB Digital radio stations are broadcast in multiplex. Each multiplex is a bundle of
radio stations transmitted in a single frequency. There are national and local multiplex; local ones
contain stations specific to your area. This option displays the name of the multiplex name that
contains the station you are listening to.
 Multiplex Number/Freq: This option will display the multiplex number and frequency that contains the
station you are listening to.
 Signal Error Rate: This option will display the level of signal errors in the current broadcast. The lower
the number, the better quality of the signal.
 Bit Rate: DAB allows broadcasters to vary the BIT RATE (or the amount by which an audio signal can
be compressed) depending on the type of broadcast. This enables the amount of stations on a
multiplex to be maximized. Speech and News are often broadcast at a lower Bit Rate; music needs a
higher Bit Rate for good fidelity.
 Time and Date: time and date are updated by broadcasted information.
DAB Setting Menu
Your radio has some additional features and options that maybe reached through the Setting Menu.
Press the MENU button to show the DAB options on the display. Turn the TUNING/SKIP knob to select
an option and press the ENTER/PLAY/PAUSE button to confirm.
 Station list: Selecting "station list" will exit the settings menu to browse the DAB station list. Stations
maybe selected from the list.
 Full scan: Select "Full scan" to re-scan the entire DAB band and refresh the station list.
 Manual tune: Manual tuning enables you to search the band manually, stepping through the multiplex
numbers to check if there is any usable signal strength.
 DRC: DRC is Dynamic Range Compression. Enabling DRC may improve the sound of DAB radio
when listening in a noisy room.
 System: This option includes DAB, FM, System setup, SW version.
System setup
 Time Setup: This option enables the clock to be set manually if there is no available DAB
transmission.
 Factory Reset: This option will restore all settings to "Factory Original". All clock and station
list and any stored preset stations will be cleared. After factory reset the radio will
automatically re-scan the DAB band when first used.
SW version: This option will display the version number of the control software currently installed
in your radio.
Listening to FM Radio
Your radio can also receive FM band radio stations and display RDS data (while broadcast).
To change to the FM band
 Press the FUNCTION button to select FM mode.
To auto-tune to FM stations
 Press the ENTER/PLAY/PAUSE button to start scanning. When an available station is found, the auto
tuning will stop and turn to broadcast the received programme.
NOTE: Auto scanning up or down depends on your last manual tuning up or down, namely, to auto
scan up, first turn the TUNING knob clockwise, then press ENTER/PLAY/PAUSE; to auto scan down,
first turn the TUNING knob anticlockwise, then press ENTER/PLAY/PAUSE.
To manually tune to FM stations
 Turn the TUNING/SKIP knob to tune the band in 50kHz steps.
All manuals and user guides at all-guides.com
EN-3