Electronic Controls; Fan Speed; Temperature Setting - LG MFL67646801 Manual Del Usuario

Control Locations

Electronic Controls

The controls will look like one of the following.

FAN SPEED

• Every time you push this button, it cycles through the settings as follows:
{High(F2) ' Low(F1) ' High(F2) ' Low(F1)}
' F
TEMP
MODE
-
Push this button to cycle through the modes from COOL ' FAN
' HEAT' COOL.
- COOL
• Fan runs continually for normal cooling operation.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the unit
will check the room air temperature to determine if cooling is
needed.
- FAN
• Fan operation without heating or cooling.
- HEAT
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2 F(1 C) after 30 minutes, and once
again after another 30 minutes.
• Push Timer to cycle through the settings from 1 Hour ' 2 Hours ' ... ' 12 Hours maximum.
14 Room Air Conditioner
All manuals and user guides at all-guides.com
E/SAVE
HEAT
FAN FAN HIGH HIGH
COOL COOL LOW LOW TIMER TIMER
ON ON
MODE FAN TIMER
OFF OFF
POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.

TEMPERATURE SETTING

• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of 54
F(12 C) to 86 F(30 C) by increments
of 1 F(0.5 ).
• The setting appears in the display.