Publicidad
Idiomas disponibles
Idiomas disponibles
te rotation of the mixing drum.
All dangerous areas on the IMER concrete mixer have protective casing
which must be kept installed at all times and maintained in perfect con-
When moving the machine manually, use the handle provided (ref.A,
The cement mixer S 140 is delivered dismantled, packed in a box. Fol-
low the instructions provided below to assemble it:
1. Fit the rest foot and the axle unit with wheels on the frame. The latter
sitioned horizontally.
respective holes on the drum.
Once assembly has been completed, the concrete mixer is ready for
use.
During mixer installation ensure easy access for barrows under the
mixer drum for loading.
IMER INTERNATIONAL S.p.A.
SYNTESI 140 EL
-
chine: 220-230V/50Hz. The electrical power cable must be suitably si-
zed to avoid voltage drops. Cable drums must not be used. The size of
the power cable wires must be based on operating current and length of
the power line to prevent excessive voltage drops (tab.3).
-
Model
Syntesi 140 EL
-
sheathing that is resistant to wear, crushing and extreme weather condi-
tions (for example H07RN-F).
Before connecting the cement mixer to the power supply, check that
all the safety devices are in place and working properly, that the power
supply cable is in good condition and that the plugs and sockets (of
the waterproof type) are not wet. Check that the metal grilles protecting
the electric motor are not clogged, to prevent overheating of the motor
itself.
Connect the power supply cable to the electric panel plug. Start the
comprises two buttons: green for switching on, red for stopping. The
switch is provided with minimum voltage protection: in the event of a
power failure due to accidental causes, to start again, press the green
start button.
-
-
-
To obtain optimum mixing and regular operation, the concrete mixer
must be installed in the horizontal position. The user should adjust the
inclination of the mixing drum depending on the mix to be made.
Drum tilt may be adjusted while materials are being loaded, in order to
keep the mix from dripping out of the drum.
Before beginning to load the materials inside the drum, it is best to pour
When loading, insert the various materials to be mixed alternately, in the
-
amounts required for the type of mix to be obtained, so as to reduce the
mixing time to a minimum.
Keep the drum running until a smooth mix having the desired consisten-
cy is obtained.
Emptying must be carried out with the mixing drum working, moving
the drum mouth downwards by turning the hand-wheel provided (ref.11,
If part of the batch is left in the drum for later use, it is necessary to leave
the drum turning. In any case, minimise the time the batch stays in the
drum after the required consistency has been reached.
12
Table 3
Cable (mm²)
Type of motor
1.5
2.5
230 V 2.2 A
0 - 35
36 - 50
220 V 2.5 A
GB
-
4.0
-
-
Publicidad
