Publicidad
Idiomas disponibles
Idiomas disponibles
Every two working months, check the following:
dirt and rubbish.
Check on a weekly basis that the contacts of the plug and socket con-
nector on the electrical panel are clean, dry and free of rust.
If the cement mixer is to be used after standing for a long time outside,
check that the tipping reduction gear is properly lubricated.
After each daily work session or before long periods of inactivity, the
mixing drum must be cleaned thoroughly both inside and outside.
When using a hose for cleaning, do not direct the spray into the plug-
switch unit.
Clean the outside of the mixer with a brush and water. Scrape off any
cement or concrete deposits.
There should not be any deposits of cement or concrete inside the drum.
The inside of the drum can be cleaned better if, at the end of the work
session or before a prolonged period of inactivity, the drum is rotated
with a few shovel-fulls of gravel and water. This will prevent any residue
of cement or concrete from hardening.
The mixing drum must not be struck with hard objects such as hammers
or shovels, etc. A dented drum will reduce the mixing effects and make
1. Switch off the electric motor and disconnect the power plug.
correct, applying a force of approx. F=0.6 Kg at the centre of the free
1. Switch off the electric motor and disconnect the power plug.
of the electric motor and reduction unit pulleys.
electric motor pulley; make sure that the three belt ridges are inserted
properly in the pulley races.
5. Pull the belt through the motor support: if the belt tension is correct,
applying a force of approx. F=0.6 Kg at the centre of the free part of the
1. Raise the machine a few centimetres from the ground, resting the
wheel axle on a sturdy and stable support (e.g. piece of wood or other
homogeneous material). The height of this piece should be slightly hi-
IMER INTERNATIONAL S.p.A.
SYNTESI 140 EL
gher than the wheel radius.
2. Pull out the split pin (ref.26, pag.20) and remove the wheel (ref.25,
pag.20).
4. Lower the machine to the ground.
drum is emptied.
If the shaft does start to turn, this brake must be replaced, using original
IMER spare parts.
Repairs to electrical systems must be carried out exclusively by spe-
cialist staff.
-
in any way.
13
GB
Publicidad
