Cameo H1 D Manual De Usuario página 21

SYSTEM SETTINGS (Settings)
Select Settings and confirm.
This will take you to the submenu for configuring the submenu items (see table):
Settings
DMX Fail = Operational status
with DMX signal
fault
Dimmer = Dimmer curve
Curve
Dimmer = Dimmer response
Re-
sponse
PWM = Configuration of
Frequen- PWM frequency
cy
Calibra- = Sets maximum
tion brightness
Hold last command is retained
Blackout Activates blackout
Full On 100% output
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted at
lower DMX values and broadly adjusted at
higher DMX values
Logarithmic Light intensity can be broadly adjusted at
lower DMX values and finely adjusted at
higher DMX values
S-curve Light intensity can be finely adjusted at
lower and higher DMX values and broadly
adjusted at medium DMX values.
LED Light responds abruptly to
changes in DMX value
Halogen Light behaves like a halogen spotlight
with slight brightness changes
800 Hz/1200
Hz/2000 Hz/
3600 Hz/12
kHz/25 kHz
White Cross-mode brightness setting with
values from 000-255
21