Publicidad
Step 19
Carefully stand your unit upright.
å
Push two DOOR STOPS (4I) into the holes in the
å
BOTTOMS (F and R).
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the LEFT DOOR (W) to the LEFT END (B) as
å
shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten a KNOB SET (136K) to the LEFT DOOR (W). Use a
å
BLACK 1-1/8" MACHINE SCREW (21S).
Repeat this step for the RIGHT DOOR (X).
å
See the next step for DOOR adjustments.
å
136K
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
www.sauder.com/services
B
W
R
21S
4I
419959
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
F
Page 23
Publicidad
