Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing
to
the
provisions
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
26.06.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle
Operate your machine only with the auxilia-
ry handle 10.
The auxiliary handle 10 can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
Turn the bottom part of the auxiliary handle 10
in counterclockwise direction and swivel the
auxiliary handle 10 to the desired position. Then
retighten the bottom part of the auxiliary handle
10 by turning in clockwise direction.
Adjusting the Drilling Depth (see figure A)
The required drilling depth X can be set with the
depth stop 11.
Loosen the wing bolt for the depth stop adjust-
ment 9 and insert the depth stop rod into the
auxiliary handle 10.
Bosch Power Tools
All manuals and user guides at all-guides.com
of
the
directives
Dr. Eckerhard Strötgen
Head of Product
Certification
Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder 1. Otherwise, the mov-
ability of the SDS-plus drilling tool can lead to
incorrect adjustment of the drilling depth.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth X.
Retighten the wing bolt for the depth stop ad-
justment 9 again.
The knurled surface of the depth stop 11 must
face upward.
Selecting the Tool Holder
For hammer drilling, SDS-plus drilling tools that
can be inserted into the SDS-plus tool holder 1
are required.
For drilling without impact in wood, metal, ce-
ramic and plastic as well as for screwdriving and
tapping, use non-SDS-plus drilling tools (e. g.,
drill bits with cylindrical shank). A keyless drill
chuck is required for such drilling tools.
Note: Do not use tools without SDS-plus for
hammer drilling or chiselling! Tools without
SDS-plus and their drill chucks are damaged by
hammer drilling or chiselling.
The SDS-plus tool holder 1 can easily be ex-
changed against the quick change keyless chuck
12.
Changing the Tool Holder
Dismounting the SDS-plus Tool Holder or the
Quick change keyless chuck (see figure B)
Turn the mode selector switch 7 temporarily to
the "drilling" position in order to lock the tool
holder.
Firmly turn the locking sleeve 3 in the direction
of the arrow and pull off the tool holder 1 or the
quick change keyless chuck 12 toward the front.
After removing, protect the tool holder 1 or the
quick change keyless chuck 12 against contami-
nation. Lightly lubricate the engaging grooves, if
required.
English | 19
1 619 929 748 | (25.7.07)